- /
- /
- /
- /
Zxd 3000 User Manual 2021
For an overview of The Admin Portal, please review the below video:
For an overview of The Admin Portal, please review the below video:
Excellent emphasis:
This section covers the standard parameters found in the technical manual.
A. AC Input Parameters
B. DC Output Parameters
C. Mechanical Characteristics
The 2021 ZXD 3000 has 18 error codes. Here are the most common:
| Code | Meaning | Solution (2021) | |------|---------|------------------| | E-04 | Power supply undervoltage (<100V) | Check wall outlet; use a line conditioner. | | E-07 | Motor overload | Reduce speed setting; clean motor fan. | | E-11 | Sensor misalignment | Run Auto Calibrate (Section 6). If persists, replace sensor (part ZXD-S21). | | E-15 | Firmware mismatch | Reinstall 2021 firmware (Section 9). | | E-22 | Overtemperature (>70°C internal) | Let unit cool for 30 minutes. Check air vents. | | E-30 | Emergency stop activated | Twist e-stop clockwise to reset; press Stop/Clear. | zxd 3000 user manual 2021
If an error persists after three power cycles, contact ZXD support with the error code and your unit’s serial number (located on the rear plate, format ZXD-21-XXXXX).
Excellent emphasis:
This section covers the standard parameters found in the technical manual.
A. AC Input Parameters
B. DC Output Parameters
C. Mechanical Characteristics
The 2021 ZXD 3000 has 18 error codes. Here are the most common:
| Code | Meaning | Solution (2021) | |------|---------|------------------| | E-04 | Power supply undervoltage (<100V) | Check wall outlet; use a line conditioner. | | E-07 | Motor overload | Reduce speed setting; clean motor fan. | | E-11 | Sensor misalignment | Run Auto Calibrate (Section 6). If persists, replace sensor (part ZXD-S21). | | E-15 | Firmware mismatch | Reinstall 2021 firmware (Section 9). | | E-22 | Overtemperature (>70°C internal) | Let unit cool for 30 minutes. Check air vents. | | E-30 | Emergency stop activated | Twist e-stop clockwise to reset; press Stop/Clear. |
If an error persists after three power cycles, contact ZXD support with the error code and your unit’s serial number (located on the rear plate, format ZXD-21-XXXXX).