top of page
Update Ktag Clone From 2.25 To 2.70

2.25 To 2.70 — Update Ktag Clone From

This is the most dangerous step. Interrupting the power or connection here will kill the tool.

  • Disconnect: Once verified, disconnect the JTAG programmer and close the KTAG casing.

    • If your Ktag is dead (no USB, no lights, PC plays "disconnect sound"), you need a hardware recovery. Update Ktag Clone From 2.25 To 2.70

  • Open STM32 Flash Loader again.
  • Hold the BOOT0 pin high. Power via 5V on the regulator output.
  • Flash your backed-up 2.25 bin file.
  • Resolder the voltage regulator leg.

    • This revives 70% of bricked clones. If the STM32 is fried, you cannot recover – buy a new board. This is the most dangerous step

    Using KTAG suite or STM32 programmer:

    bottom of page