 |
||
| ||
|
The ME7.4.5 utilizes two main connectors plugged into the side of the unit.
Note: Pin numbering follows standard Bosch conventions (looking at the ECU pins from the harness connector side, pins are numbered left-to-right, top-to-bottom). me7.4.5 pinout
Tap the MAP sensor signal from pin 43 directly, but be aware: the MAP is inside the ECU case. Instead, install a dedicated boost gauge line from the intake manifold. The ME7
The ME7.4.5 uses a "Drive-by-Wire" system. pins are numbered left-to-right
| Pin | Signal | Description | |------|----------------|------------------------------| | 1 | Power | Permanent +12V (ECU main) | | 2 | Ground | Power ground | | 3 | Ignition output | Ignition coil cylinder 1 | | 4 | Ignition output | Ignition coil cylinder 2 | | 5 | Ignition output | Ignition coil cylinder 3 | | 6 | Ignition output | Ignition coil cylinder 4 | | 7 | Injector output | Injector cylinder 1 | | 8 | Injector output | Injector cylinder 2 | | 9 | Injector output | Injector cylinder 3 | | 10 | Injector output | Injector cylinder 4 | | 11 | O2 sensor heater | Pre-cat O2 heater (bank1) | | 12 | O2 sensor heater | Post-cat O2 heater | | 13 | MAF signal | Mass air flow sensor signal | | 14 | MAF ground | Sensor ground | | 15 | Sensor +5V | Reference voltage | | 16 | Throttle position | TPS signal | | 17 | MAP sensor | Manifold absolute pressure | | 18 | IAT sensor | Intake air temp | | 19 | ECT sensor | Engine coolant temp | | 20 | Knock sensor 1 | Signal | | 21 | Knock sensor 2 | Signal | | 22 | Cam position | Hall sensor signal | | 23 | Engine speed | Crank sensor signal | | 24 | CAN low | Diagnostic CAN bus | | 25 | CAN high | Diagnostic CAN bus | | 26 | K-line | Diagnostic K-line (ISO 9141) | | 27 | N75 valve | Boost control solenoid | | 28 | EVAP purge | Purge valve control | | 29 | SA output | Secondary air injection relay | | 30 | Fuel pump relay | Control signal | | 31 | Main relay | Power supply relay control | | 32 | Ground | Sensor ground | | 33 | +5V | Sensor supply | | 34 | TPS ground | Throttle position ground |
(Full 121-pin table available in Bosch ME7.5/7.4 factory documentation – above are most commonly used pins.)
Impressum
und rechtliche Hinweise
Datenschutzerklärung