Jungheinrich Etv 216 Error Codes May 2026

Steering on the ETV 216 is fully electronic/hydraulic (steer-by-wire on some variants).

| Code | Description | Common Root Cause | Immediate Action | |------|-------------|--------------------|-------------------| | 672 03 | Steering angle sensor not calibrated | After steering unit replacement or power loss | Perform steering calibration: turn wheel full left, full right, then center. Confirm via CanDis. | | 672 08 | Steering motor torque excessive | Mechanical binding in steering gear or kingpin | Disconnect motor and turn wheel manually. Grease steering kingpin bearings. | | 674 02 | Joystick steering signal missing | Potentiometer worn out in mini-joystick (armrest) | Replace joystick module. There is no repair for the internal pot. |

Meaning: The CAN-based LED light cluster on the right side is not responding.

Symptoms: Turn signal or tail light not working. No bulb-out warning on older systems. jungheinrich etv 216 error codes

Causes:

Solution:

Meaning: Battery voltage has dropped below the truck’s minimum operating threshold (typically 36V for a 48V system under load). Steering on the ETV 216 is fully electronic/hydraulic

Symptoms: Lift speed reduces dramatically; travel speed is limited to “creep mode.”

Causes:

Solution:

Most error codes on the ETV 216 are preventable. Follow this PM checklist every 500 operating hours:

Meaning: The parking brake fails to release when the operator attempts to drive.

Symptoms: The truck will not move. You hear a relay click but no release. Solution:

Causes:

Solution: