Bystronic Laser Error Code List -
| Error Code | Message | Immediate Fix | | :--- | :--- | :--- | | 7005 | Chiller flow rate too low | Check pump impeller; clean Y-strainer; look for kinked hoses. | | 7020 | Chiller water conductivity high (Fiber) | Deionized cartridges exhausted. Replace DI resin and test conductivity (<0.1 µS/cm). |
| Code | Description | |------|-------------| | E-2015 | Capacitive height sensor out of range | Nozzle touching plate, cable broken | | E-2020 | Focus position not reachable | Motor / encoder issue | | E-2025 | Nozzle change failed | Gripper or magazine position error | | E-2030 | Collision detected | Head crashed into sheet or part | | E-2040 | Lens temperature too high | Dirty lens, insufficient cooling | bystronic laser error code list
The "smart" proximity that keeps the nozzle off the plate. | Error Code | Message | Immediate Fix
| Error Code | Description | Likely Cause | Immediate Fix | | :--- | :--- | :--- | :--- | | E-3010 | Capacitive sensor fault | Broken wire in head harness or dust contamination | Clean the ceramic ring. Inspect cable for cuts. | | W-3022 | Gap voltage unstable | Rust on sheet surface or heavy oil | Ground the sheet directly. Use anti-spatter spray. | | E-3045 | Nozzle stuck / Not centered | Thermal expansion tightened the nozzle | Replace nozzle. Lubricate threads with copper paste. | | E-3100 | Focus position not reached | Motorized lens stuck | Remove lens cartridge. Clean dovetail slides. | | W-3150 | Lens contamination warning | Beam splatter on protective glass | Rotate protective glass (if equipped). Replace. | Deeper diagnostics:
Below is a curated Bystronic laser error code list with real-world explanations. Note that firmware versions vary slightly; always verify with your machine’s ByVision or BySoft interface.
Never bypass safety errors. These exist to protect your eyes and hands from high-powered beams.
| Error Code | Message | Solution | | :--- | :--- | :--- | | 6101 | Safety circuit open | One of the interlock switches (door, panel, E-stop) is open. Walk perimeter and check all doors. | | 6110 | Light barrier contaminated | Dust or slag on protective window of beam stop. Clean with alcohol and microcloth. | | 6125 | Emergency stop button latched | Twist all red E-stop buttons until they pop out. Then confirm reset in software. |